The PV Facts2 Main Screen. Just connect your Fantom Dyno to your computer, start the PV Facts2 program, select a motor description and touch the Enter Key.

Motor Test Results Screen. After the motor is 'run up' the next screen you see is the label itself. If you don't want the data you can always touch the Escape Key.

Did you notice? Select 5 or 7 volt test setting. Modified Fantom Dynos can test motors at 7 volts. And that... Torque may be expressed as gm/cm or Nmm.

Enter your own Motor Descriptions and Part Numbers. Add as many motors with their individual descriptions and part numbers as you like.

Select a Test Time under the Options Menu. Run each motor test for 3, 4 or 5 seconds.

Print a label right after the motor is tested. or save a 'batch' of tests to print later.

Print saved motor labels when you're ready. Touch the F-6 Key to expose the Print Preview Window.

Select the starting label position on the Print Preview Window. Just move your mouse pointer to the label you want to start the printing and click. The labels will lay themselves out again, starting at the label you clicked. The program will always tell you to put one more sheet of labels into the printer paper feed bin based on the number of labels you have to print at the time.

Order Label Sticker Sheets $3.00 per sheet of 77 stickers & U.S. Postage $75.00 per pack of 100 sheets PLUS shipping UPS or Postal Contact me with your needs.

Use the Print Alignment Window to print Label Outlines on a test page. When the outlines are adjusted so they print right over the labels then your text or label information will print 'centered' within the label edges.

This page and it's contents are Copyright 2002 ~ 2006 by Dave Clary, DBA; decCo SoftWare.